keyestudio Keyestudio UNO R3 BOARD Introduction: Keyestudio UNO R3 development board is a microcontroller board based on the ATmega328P (datasheet), fully compatible with ARDUINO UNO REV3. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, 2 ICSP headers and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. Note that the two ICSP headers separately used to program the firmware to ATMEGA16U2-MU and ATMEGA328P-PU, but we have programmed the two chips, so generally no need to use them. The Uno R3 differs from all preceding boards in that it does not use the FTDI www.keyestudio.com 1 keyestudio USB-to-serial driver chip. Instead, it features the Atmega16U2 programmed as a USB-to-serial converter. The UNO is the best board to get started with electronics and coding. If this is your first experience tinkering with the platform, the UNO is the most robust board you can start playing with. TECH SPECS: Microcontroller ATmega328P-PU Operating Voltage 5V Input Voltage (recommended) 7-12V Digital I/O Pins 14 (of which 6 provide PWM output) PWM Digital I/O Pins 6 (D3, D5, D6, D9, D10, D11) Analog Input Pins 6 (A0-A5) DC Current per I/O Pin 20 mA DC Current for 3.3V Pin 50 mA Flash Memory 32 KB (ATmega328P-PU) of which 0.5 KB used by bootloader SRAM 2 KB (ATmega328P-PU) EEPROM 1 KB (ATmega328P-PU) Clock Speed 16 MHz LED_BUILTIN D13 www.keyestudio.com 2 keyestudio Dimensions: www.keyestudio.com 3 keyestudio Element and Interfaces: Here is an explanation of what every element and interface of the board does: www.keyestudio.com 4 keyestudio ICSP (In-Circuit Serial Programming) Header In most case, ICSP is the AVR ， an Arduino micro-program header consisting of MOSI, MISO, SCK, RESET, VCC, and GND. It is often c