ECK-10_REV-O_091416.qxp_ECK-10 9/14/16 2:49 PM Page 1 BASIC ELECTRONIC COMPONENTS MODEL ECK-10 Resistors Coils Capacitors Others Semiconductors Transformers (not included) Instruction Manual by Arthur F. Seymour MSEE It is the intention of this course to teach the fundamental operation of basic electronic components by comparison to drawings of equivalent mechanical parts. It must be understood that the mechanical circuits would operate much slower than their electronic counterparts and one-to-one correlation can never be achieved. The comparisons will, however, give an insight to each of the fundamental electronic components used in every electronic product. ELENCO ® Copyright © 2016, 1994 by ELENCO® Electronics, Inc. All rights reserved. Revised 2016 REV-O No part of this book shall be reproduced by any means; electronic, photocopying, or otherwise without written permission from the publisher. 753254 ECK-10_REV-O_091416.qxp_ECK-10 9/14/16 2:49 PM Page 2 RESISTORS RESISTORS, What do they do? The electronic component known as the resistor is best described as electrical friction. Pretend, for a moment, that electricity travels through hollow pipes like water. Assume two pipes are filled with water and one pipe has very rough walls. It would be easy to say that it is more difficult to push the water through the rough-walled pipe than through a pipe with smooth walls. The pipe with rough walls could be described as having more resistance to movement than the smooth one. Electrons flow through materials when a pressure (called voltage in electronics) is placed on one end of the material forcing the electrons to “react” with each other until the ones on the other end of the material move out. Some materials hold on to their electrons more than others making it more difficult for the electrons to move. These materials have a higher resistance to the flow of electricity (called current in electronics) than the ones that allow electrons to move easily